Brief introduction of copper and brass strip production process

Brief introduction of copper and brass strip production process

copper and brass strip is a common copper belt material in industry, and its application is very wide. In the process of production, every process should be carefully treated in order to produce qualified finished products. Its production process is as follows:

1. Embryo preparation. This is an important step in the production of brass tape. It is necessary to add different amounts of zinc to the scrap copper material according to the predetermined production target, so as to produce different specifications of copper raw material.

2. Test. This step is to ensure the quality of the finished product. The test results should be handed over to the furnace personnel.

3. Cut it. This process is conducive to the post-processing brass strip surface to maintain smooth and smooth.

4. Hot rolling. The cut copper strip is heated at 1000℃ and then hot rolled into a copper strip with a thickness of about 2.3cm.

5. Wash in water. This step is to wash impurities from the surface of the brass tape. Because there will be certain impurities on the surface of the copper block after the initial rolling, it is necessary to remove these impurities through the washing process.

6. Rolling plate. The latter process is to refine the copper strip, which has been calcined in a furnace.

In the production process of copper belt and copper and brass strip, the requirements of each process are very strict. No matter which step, we should strictly comply with the requirements. To grasp the details of the production process, do not take lightly, so as to produce good quality finished products.